Page MenuHomePhorge
Diviner User Docs Drydock User Guide: Repository Automation

Drydock User Guide: Repository Automation
Phorge Administrator and User Documentation (Application User Guides)

Configuring repository automation so Phorge can push commits.

Overview

IMPORTANT: This feature is very new and some of the capabilities described in this document are not yet available. This feature as a whole is a prototype.

By configuring Drydock and Diffusion appropriately, you can enable Repository Automation for a repository. This will allow Phorge to make changes to the repository.

Limitations

  • This feature is a prototype.
  • Only Git is supported.

Security

Configuring repository automation amounts to telling Phorge where it should perform working copy operations (like merges, cherry-picks and pushes) when doing writes.

Depending on how stringent you are about change control, you may want to make sure these processes are isolated and can not be tampered with. If you run tests and automation on the same hardware, tests may be able to interfere with automation. You can read more about this in Drydock User Guide: Security.

Configuring Automation

To configure automation, use Edit RepositoryEdit Automation from Diffusion.

On the configuration screen, specify one or more working copy blueprints in Drydock (usually, you'll just use one). Repository automation will use working copies built by these blueprints to perform merges and push changes.

For more details on configuring these blueprints, see Drydock Blueprints: Working Copies.

After selecting one or more blueprints, make sure you authorize the repository to use them. Automation operations won't be able to proceed until you do. The UI will remind you if you have unauthorized blueprints selected.

Testing Configuration

Once the blueprints are configured and authorized, use Test Configuration to check that things are configured correctly. This will build a working copy in Drydock, connect to it, and run a trivial command (like git status) to make sure things work.

If it's the first time you're doing this, it may take a few moments since it will need to clone a fresh working copy.

If the test is successful, your configuration is generally in good shape. If not, it should give you more details about what went wrong.

Since the test doesn't actually do a push, it's possible that you may have everything configured properly except write access. In this case, you'll run into a permission error when you try to actually perform a merge or other similar write. If you do, adjust permissions or credentials appropriately so the working copy can be pushed from.

Next Steps

Continue by: